| Inspection and Care
of the Site |
|
During the early stages of development take
note of the following:
- Remove all dressings to inspect INTEGRA™
Matrix Wound Dressing sites, seams, and edges for evidence
of hematomas, fluid accumulation, infection/purulence,
and areas of non-take.
- If used,
re-moisten antimicrobial dressings after INTEGRA™
Matrix Wound Dressing inspection. Irrigation
tubing can be used to re-moisten or re-apply without
removing dressings.
- Re-moisten or re-apply antimicrobial
dressings as needed, typically every eight hours, or
more often for dry climates
- Replace or change antimicrobial dressings
at least every three days. Note: For heavily draining
wounds, more frequent dressing changes may be necessary.
When removing dressings to inspect INTEGRA™ Matrix Wound Dressing sites, care should
be taken to avoid dislodgement. As you gain experience
with INTEGRA™ Matrix Wound Dressing, your frequency of inspection and
dressing changes is likely to change from this schedule.
Movement / Outpatient Care
As shearing will result in the NON-TAKE of INTEGRA™ Matrix Wound Dressing, the goal for the staff
and patient is to minimize these forces on the INTEGRA™ Matrix Wound Dressing site. Bolsters, splints,
casts and Ace Wrap compression will help protect from
friction and will reduce the likelihood of the product
shearing from the excised bed.
